Elementary my dear Watson!

It's been 6 weeks since I sent a sample of my tank water off to Triton for ICP analysis. My maintenance routine has been pretty much the same since although I've been changing out slightly more water than usual (12-14% as opposed to 10%, I would perform more if I could but the buckets I use only hold 25l so I can't perform larger water changes easily), I've also been dosing trace elements, in particular iodine as it was undetectable. I thought it was time to see how things stood now.

I was going to use the Triton test again for continuity but discovered that ATI offer a test for RO water in addition to tank water analysis so it was a no brainer for me, ATI was the obvious choice. I have always wanted to know for sure that the RO water I use is without contaminants.

First up is the tank water analysis:

As you can see I still have an issue with tin, if the Triton and ATI ICP machines are compatible then you could say it's dropped a little (from 12.00 to 10.48ug/l) but as far as I'm concerned there is not much change at all. I do have an iodine reading now which is good news it's still low but a lot better than 0 (at least I'm assuming it is, lol). My nitrate and phosphate levels are still low despite feeding, what seems to me, a lot of food. The Siporax and/or refugium appear to be working well, a bit too well it would seem.

Now on to the RO analysis, results below:

I am happy to see that apart from a touch of molybdenum the water looks squeaky clean, not a whiff of tin which is reassuring. Water changes must be helping keep the tin level from rising further but not enough to actually lower the level, I must assume that whatever is leaching the tin that it must still be doing so. Almost all of my equipment is brand new with the exception of a couple of small pumps running the refugium and the pump that I use for water changes. They look fine but I've decided to change them out just in case. I replaced the old glass heater that I used in my water change bucket last month ago as it seemed like an obvious suspect.

As far as the corals go they seem to be doing OK at the moment with no sign of any flesh stripping which apparently can result after long term exposure to a high level of tin. I hope I can find the source and fix it before I reach that point, assuming of course it's not coming from the glass itself in which case I'm stuffed.